Introduction
You can use any touch screen but we supply ELOtouch screen because of our experience with them. This article is specific to ELO but others will require a similar setup process.
With all applications including Artist shut down, install the drivers from the disk supplied from ELO. Often you will use the touch screen as a second monitor. If this is the case ensure you have set whether the monitor is the primary or secondary – usually the secondary.
Setting up Artist
This procedure sets the Operator to automaticall open in full screen mode on a specified monitor when Atrist is launched.
- Run Artist
- click on Operator to open the operator GUI
- press ‘F2’ or select Properties from the menu bar
- select the Display tab
- select the monitor from the Screen Setup combo box.
- click OK
- press ctrl-X to close the operator screen
- main menu/Tools/Preferences/Start Up
- check Operator GUI
- click OK
Now save the workspace.