by Mick Martin | Aug 29, 2012 | Knowledge Base
This procedure sets up one 8 port XNet interface on Artnet. Computer Setup Set the IP address of the Ethernet port on the Artist computer to 2.0.0.1 and the sub-net mask to 255.0.0.0Start ArtistRight-click Navigator/Resources/Interface Manager/Artnet and select...
by Mick Martin | Aug 2, 2012 | Knowledge Base
Sunlite no longer support the interfaces that we use to supply with Artist. However, it still can be used under certain circumstances. It will only work under 32 bit Windows XP or later. You must install the drivers using Artist 2 and then you can run Artist 3 if...
by Mick Martin | Apr 24, 2012 | Knowledge Base
Artist Status Bar There is a section here labelled BPM with a number box and a check box labelled Auto. Auto BPM When the box is check the BPM displayed is calculated from the input audio source. The calculation can be finely adjusted in...
by Bob Calvert | Mar 23, 2012 | Knowledge Base
The CD/DVD drive in your computer is not recommended for timecode shows becuase in general removable optical media is are reliable. We therefore suggest that you rip the CDs to the hard drive and play the content from there. The sound quality will then be...
by Mick Martin | Mar 21, 2012 | Knowledge Base
The X-Net 8 has an inexplicably complicated switch setting. In this article I do my best to explain it. The possible addresses are in the range 2.39.2.4 to 2.39.2.250. Each address setting occupies 2 address slots. So, for example, Sw1 = 1, Sw2 = 3, Sw3 = 0...
by Mick Martin | Mar 19, 2012 | Knowledge Base
Artist does not output time code currently. You therefore require an external MTC time code generator. Create a MIDI time event file and insert you synchronisation events to start Artist cues and lists at specific time periods. Then do the...
